BigBendFishing.Net

When I was on the water and it would not start I thought it was a fuel issue, so i checked the carb and it had fuel in it. I drained it and filled it back up still no luck.

yes vent is open, non ethanol with fuel treatment also...

Hey guys,
Long time since last post. Ended up cleaning carb, no luck. Found the issue to be one of the plug wires. Replaced plug wire. Took the gheenoe out to test the motor, ran great for about 20 seconds, then then motor bumped up, rev'd really high and then shut off, could not get the motor to ...

It was liquid, I poured it in and I did not notice a change in rpms...

Is there a different chemtool I should be using rather than the fuel treatment?

I'm not sure about the hub. Works fine at idle speed in forward and reverse. Just seems like I'm not getting enough power when I give it gas. Not turning anywhere near the rpms. the "knocking" sound in neutral is a loud bang every 10-15 sec, and is another unknown issue.

Exhaust is fine. Runs the same with / without cowling. Also plenty of water spitting out.

PA, thanks for the reply. I went out and bought some chemtool, all I could find is the chemtool fuel treatment. Tried it and still no luck. Also there is a "knocking" noise every once in awhile,but only in neutral. I am running non ethanol gas with sea foam treatment.

Hey guys. Ive been having some issues with my sportwin 9.5. Ran fine when I got it. It started to run bad a few weeks ago. I have now cleaned carb. Checked fuel lines. Replaced plugs. No difference, i now have checked and set points, pulled flywheel and turned motor until the gaps were at the widest ...