BigBendFishing.Net

PM replied to.

1998 Cape Horn 24 (24’10” LOA), 2005 Yamaha 250HPDI outboard, 2009 Seahawk Aluminum Trailer $20,000 Electronics include Garmin 2010 Chartplotter, Furuno 600L Bottom Machine, Furuno 1620, 16 nm Radar, Furuno GP 35 Differential GPS, Apelco 6400 Loran/GPS unit, Standard Horizon Intrepid DSC capable VHF...

1998 Magic Tilt Aluminum, tandem axle trailer. Galvanized drop axles replaced 2006, Galvanized hubs and tires replaced August 2008. 2 of the 3 original galvanized cross members replaced with aluminum tube cross members from manufacturer in 2008. Wood bunks & carpet are in very good shape and are...

Ruger Mini 14 Ranch Rifle, .223, Stainless. Original wood stock, Tapco Fusion collapsible stock, original 5 round magazine, 2-30 round polymer mags, 2- 20 round nickeled mags. Factory scope rings. The original folding rear site has been replaced with a Williams peep sight. 40 rounds of ammo. Asking ...

Don, I have a 14.25 X 17P Stiletto prop that only has about two hours of use on it. It uses the torque flow hub system, but I don't have that in it. You are welcome to give it a try and see if it gives you any better performance. It came with my 250 HPDI, but didn't have enough surface area to push ...

Bailey,

Check out the Lighthouse Children's/Thrift store on US 90, just East of I-10. I noticed a small trailer sitting there on my way home yesterday.

It's a law alright. Commonly called the "Laws of Gross Tonnage." He stated that the Captain of the cattle boat (dive charter) spoke to the other captains. The conversation probably went something like, "Scoot over monkeyboats, I'm about to dump a load of divers in the water whether yo...

I recently lifted my 250 HPDI using the trailer jack method and it was a walk in the park. I think you will be surprised at the difference lifting the motor will make, or at least I was. My 24 Cape Horn had a 250 EFI Merc on the back and I replaced it with the HPDI. I lost 10 knots of top end with t...

Dplug, where can I pick it up? I live in Tallahassee, off N. Monroe, north of the interstate. I work at the intersection of Magnolia and the Parkway.

Travis
545-8598

BTT

You may want to check the dimensions of your current prop. I don't think anyone is making a 16.75 inch diameter prop for that engine. ( Not enough clearance for it to turn).

1998 Mercury 250HP EFI 30" shaft. Includes controls and oil tank. Runs strong, with even compression on all 6 cylinders.

$4,500 Or make me an offer.

I guess it was a case of personal preference on appearances. The truck (4X4) just didn't look right with those tires on it, so I put a set of 285/75/16 all terrain tires on . I had origanally planned to put them on my wife's Nissan Crew Cab, but they are just a touch too big for it.

I have 4 General Grabber AW tires for sale. They are size 255/70/16. I took them off my F-150 Supercrew with less than 500 miles on them. Asking $300 OBO. Located in Tallahassee.

There gone!!

Last summer I was stopped by 3 FWC officers in a nice new Edgewater. GPS said it was 23 miles to the St. Marks Channel. They do travel well outside of "state" waters.