Poling Platform Metal Fabricator Wanted

Need to buy or sell something, post it here.(Only Sponsor Businesses Please)

Moderators: bman, Chalk, Tom Keels

Post Reply
User avatar
fishinfool
Site Sponsor
Posts: 3091
Joined: June 17th, 2009, 8:58 pm

Poling Platform Metal Fabricator Wanted

Post by fishinfool »

After my repower from a 90 two stroke to a 115 4 stroke I need someone to raise my poling platform. Looking to make it eight inches taller to accommodate the added height of the engine. As it is now I cannot tilt the propeller out of the water.
silverking
Site Sponsor
Posts: 5113
Joined: June 29th, 2003, 6:31 pm
Location: Panhandler

Re: Poling Platform Metal Fabricator Wanted

Post by silverking »

Metal Fabrication of Tallahassee. They are anglers themselves and can fix you up, Jim.

On Weems Road. Tell 'em I sent you. They have done several custom projects for me. Great folks and quality workmanship.
"Sun rise and sun sets. Since the beginning, it hasn't changed yet." Little Feat
User avatar
FishWithChris
Moderator
Posts: 1400
Joined: March 6th, 2009, 3:38 pm
Location: Inshore

Re: Poling Platform Metal Fabricator Wanted

Post by FishWithChris »

Bryson will get ya set up there at MetalFab.

Rich also does good work over at Rich's Welding.

sent from the Ketchup Packet

Three-fourths of the Earth's surface is water, and one-fourth is land. It is quite clear that the good Lord intended us to spend triple the amount of time fishing as taking care of the lawn. ~Chuck Clark

Image Image Image
User avatar
fishinfool
Site Sponsor
Posts: 3091
Joined: June 17th, 2009, 8:58 pm

Re: Poling Platform Metal Fabricator Wanted

Post by fishinfool »

Thanks guys, I will give them a call. :thumbup: :thumbup:
Post Reply