BigBendFishing.Net

Custom made stainless steel Porter Rock Guard (like new)

Fits 1998 200HP Mercury

Protect your lower unit from those vicious Apalachee Bay rocks

$50

Located in East Tally

Got pic on motor? Think might be same foot as my 115 2007 Optimax

Hit-n-Miss wrote: ↑October 3rd, 2021, 11:23 am Got pic on motor? Think might be same foot as my 115 2007 Optimax

I do not unfortunately.

There is a picture of the rock guard on Facebook marketplace.

Or you can text me at (850) 766-4547 and I can send you the picture.

I was under the impression that he cut down the skeg so it didn't add length. If so, not sure it would fit on a factory foot.
Would be interested to know if this is correct.

He has made 4 rock guards for me on 4 different boats and never cut any off.

Fish Masterson wrote:I was under the impression that he cut down the skeg so it didn't add length. If so, not sure it would fit on a factory foot.
Would be interested to know if this is correct.

Porter’s rock guard is a reinforcement of the skeg and he doesn’t remove any parts of the skeg by shortening the length.


Sent from my iPhone using Tapatalk

Not sure where i came up with that idea. Thanks for clarifying.

Fish Masterson wrote:Not sure where i came up with that idea. Thanks for clarifying.

No worries, if you were to look at the guard it could appear that’s how it would be done. The bottom point of the skeg is covered with the guard so it wasn’t a bad observation.


Sent from my iPhone using Tapatalk

Bump