Page 2 of 2
Posted: September 19th, 2007, 6:11 pm
by birddog
Jumptrout51 wrote:birddog wrote:The Bob's stabilizer plate I had on my 40 h.p. Merc was awesome.
Is your avatar a video of when you were a girlyman dancer in college?
I did find some old footage of you dancing in college
you seem to have lost your tan and put on a few lbs.
Posted: September 19th, 2007, 6:19 pm
by Jumptrout51
Dats' my bro' bro'.I wear jockeys.
Posted: September 19th, 2007, 7:06 pm
by Redbelly
Dis thread is fo' prop info....not girlyman dancer info!!
I did NOT ax fer dat dere......
Posted: September 19th, 2007, 9:00 pm
by Squall Line
If you want a Power Tech prop, order it from Bob's Machine shop direct... He sells the polished ones (4 blade accellator ) for $350 + 12 drop shipping , and tax to FL... not too bad of a deal overall. Maybe you can get that plate at the same time
. I would have one on my boat if it weren't for the already tight squeeze getting the boat in the garage.
Posted: September 19th, 2007, 9:26 pm
by Redbelly
Well, Propco has a 3 blade for $280 that I want to try. Peter has been a boating engineer for 50 years, and seemed very knowledgable to me.
He agrees that a 40 4 stroke will not do much better on hole shot going to a 4 blade, because of the low end torgue being weak.
He seemed to have no hesitation in suggesting what should work. A 12X11 is what he thinks will give me better hole shot and increase my rpms.
After that I will see if I want to try a Bob's plate.