BigBendFishing.Net

Sweet lookin hunk o' metal there tin can. That'll do some damage to a oyster bar!

Is it a tunnel? What HP ya got hanging off the back?

Redbelly wrote: Is it a tunnel? What HP ya got hanging off the back?

It is not a tunnel. Don't need one. That's a 2 stroke, carbed, Yamaha 115.

A 115 hp?! That thang will scat I bet! What length did you get?

Redbelly wrote:A 115 hp?! That thang will scat I bet! What length did you get?

20' 2"

tin can's 20' tin can......can do it

tin can wrote:

Redbelly wrote:A 115 hp?! That thang will scat I bet! What length did you get?

20' 2"

That thang looks like a custom. Where's it made? Mind saying how much one like 'at cost? I'd like to see if I could afford one similar. Thanks.

Pinocchio wrote:

tin can wrote:

Redbelly wrote:A 115 hp?! That thang will scat I bet! What length did you get?

20' 2"

That thang looks like a custom. Where's it made? Mind saying how much one like 'at cost? I'd like to see if I could afford one similar. Thanks.

That one is custom. That's the only one like it at this time. However, Gatortrax will customize a boat any way you want it, and would be more than glad to build you one just like it. As far as cost, there's a story behind this boat that I won't get into on this forum. If you would like information on the boat, PM me, or give Fred or Quinn a call at Parkway Marine. They're the local Gatortrax dealer, and this boat was purchased from them.

By the way, they are a BBFN sponsor.

http://parkwaymarine.bigbendfishing.net/" onclick="window.open(this.href);return false;

I want one very nice

How does it ride in chop-chop? I don't see any "v".

Nice boat TC! I would probably fall off with no rails and all, but it looks like a sweet fishing machine.


If I remember correctly, gatortrax is out of Louisiana.

grim reeler wrote:
If I remember correctly, gatortrax is out of Louisiana.

That would be correct. The factory is in Springfield , Louisiana. Parkway Marine is the local dealer.