BigBendFishing.Net

I've got a single axle aluminum boat trailer for up to at least a 20 foot boat for sale (might could put a 21 on it). It has just had the springs and hubs replaced in the last 60 days. $650 with boat on it or $750 without boat.

It also has an electric winch on it and a free 1970's 20 foot proline flats project boat sitting on it now.

do you have a picture

Aya and when I get back from Maine, I'll send you some.

Here are some pictures of the trailer, along with pictures of the free 20 foot proline project boat. If you only want the trailer, I can arrange to have the boat removed. The motor is gone.







Since these pictures were taken, I've had new springs and new hubs put on the trailer.

I sent you a message about the boat and trailer.

Interested in the boat and trailer. Let me know if it is still available. Thanks.

Yes sir, they are still available unless cmatt beats you to them. They are located at Valdosta Outboard. Its is right off of the N. Valdosta Rd exit of I-75. Take a right at the first light and it is down on the right about 1/2 mile down the road.

Thanks MD. How would I make arrangements to see it? Is the gate at Valdosta Outboard open? Is it possible to see it Saturday early AM? Thanks.

There is no fench at VD outboard, or at least not since the last time was there.

You talkin Californi talk again Don

Don right, there isn't a fence. They are open until noon or a little after on Saturday.

MD-Is the trailer (and boat) still available? Thinking about making a run up there over the weekend. Thanks.

Yep, it is still available.

I went down Wed and looked at it. The boat look like a good project. The trailer fender bracket on the passenger side needs to be welded back on. I liked the lines of the boat. I might be interested if you make me a real good deal!

Hmmm, the last time I saw it, the fender bracket had been welded back on. I'm below my cost now...how good of a deal do you need?