BigBendFishing.Net

Hello everyone. I recently found you guys here and I now peek in regularly at the site. I live in Wakulla county close to St. Marks, so I [/b]probably see a lot of you guys out on the water.

I own a 19' Carolina skiff and recently decided to construct a rear casting deck on it. Having considerable carpentry knowlege, I constructed the platform from pressure treated lumber and plywood. NOT having fiberglass knowlege, I just read from an online product spec to NOT use pressure treated plywood for glass work due to the inability for the resin to permeate the grain of the wood. This can cause future delamination.

Anybody have any background with this? Is there any type of bonding agent to pre apply to the deck before I glass it?
Thanks

The reason they say not to use it because pressure treating is a wet process and the wood is generally wet when you buy it...If you allow it to dry out and test with a moisture tester until it is dry, you should be able to achieve a good bond...There maybe some chemical issues, but I wouldn't think it would be an issue if the wood is dry.

But if I was starting from scratch, I wouldn't use PT wood, I use mahogany on my wood boats.

Hey, you got any pictures? Iwanna replace my rear deck on my skiff.