Page 1 of 1
Gluing carpet to aluminum hull - what to use
Posted: September 10th, 2007, 2:38 pm
by BlindHog
I need suggestions on what to use to glue indoor/outdoor carpet down in the floor of an aluminum boat.
I have used what Lowes sells once and it was a pain. (Trowel and can)
How about one of the Liquid nails products (caulk tube) ?
Posted: September 10th, 2007, 3:15 pm
by PerryFisherMan
It has been several years ago since I used it, but there is a glue made for the indoor/outdoor carpet that is applied with a brush. If I remember right it is a brown color and a little "rubbery" when applied. I put it on my aluminum john boat and it lasted for a long time. Most recently, I used the same thing on my Mom's porch ~ 2 yrs ago and it is still holding well. I purchased the glue and carpeting at Lowes.
Good luck.
Posted: September 10th, 2007, 4:03 pm
by wevans
This is what most marine carpet installers recommend useing
http://www.outdoorsuperstore.com/produc ... rod=264927
Posted: September 10th, 2007, 9:53 pm
by Barhopr
Don't do it!!!! use Seadek.
http://www.seadek.com/
Posted: September 11th, 2007, 12:16 pm
by BlindHog
Thanks. Found out my can of outdoor carpet glue was still good despite being 18 mos old, so I used it. Had figured it would be hardened. Cheap as I am, and ugly as my boat is, this was fine.