BigBendFishing.Net

Who has one of any sort? And how does it work for you? Do you like it? I have a 19' kenner with a 115 opti. that I am thinking about putting one on.

I all so have a kenner 19ft i had trim tabs on it but theman at carters Marine said that the kenners don't need them it get up great My boat is a tunnel hull with a jack plate also and i have no trouble getting om plane with the (0 hp motor..still have the trim tab laying around the barn collecting dust

Seems to be an echo in here!

Just kidding! Sea Dawg that's a really nice looking boat you have...tunnel and jackplate make all the difference for sure!

Hey Rhtfish

How you doing are you going to make it down to ancky this weekend thu the holidays
Im leaveing about a hr from now going down..

Bob's stabilizer plate I love mine and since it's made from aircraft aluminum, I can use it as a step ta get in the boat also

I am gonna order a Bob's next week.

I also have 19' Kenner with tunnel and Yamaha 90 put a hydro foil on mine helps me keep water on prop when turning at a high speed had trim tabs also due to the fact that my spouse is lighter than me and it would help with a port side list I have, however I been fixing that with weight distribution.

I have a bobs plate someware around the house, came off my 115 yamaha, worked great until i changed motors. 40.00 shipped

Does it hurt the value of the motor to drill holes in the motor flange for the hydrofoil? Does the foil make a huge improvement? My 200 Yam sits down way too low at less than half trottle. I am a little confused on tabs, flaps, plates, jacks. I promise to be less needy and more helpful when I get educated. Thanks for any assistance. I have read the thread started by BB back in April.