BigBendFishing.Net

Anyplace top buy Star Board in Tallahassee, just need small scrap piece to glue to the inside of my console to mount a fuse block to...
RF

Well - Boaters World has it but it must be made of gold (or oil) for what they want for a 12 x 24 piece....

I need to mount the fuse block on the console wall, but the block is made for the bolts to go behind it, and if I do that the bolt heads will be under the rod holders on the outside... any ideas on mounting? maybe Gorilla Glue the whole block to the inside, but i hate not being able to remove it if ever needed....

go to someplace like tallahassee marine...maybe they have a scrap piece laying around from rigging a boat.
I think they also have some smaller pieces at West Marine

Barhopr is right. Tallahassee Marine probably has a small piece they could help you with.

corroded fuse on the GPS went out last time after catching bait for 1 1/2 hours and fillin the well, not fun tracking down the culprit, time to rewire!

Barhopr wrote:go to someplace like tallahassee marine...maybe they have a scrap piece laying around from rigging a boat.
I think they also have some smaller pieces at West Marine

That's where I've gotten mine from or just about any boat place that does any rigging.

Would a cutting board from wal mart or lowes work?

What a mess wrote:Would a cutting board from wal mart or lowes work?

Yes. This panel is made from a piece of cutting board.



Redfin, if you don't want to use a piece of cutting board and can't find a piece of starboard, let me know. I have a few scraps.

The largest cutting board I have seen was either lowes or home depot can't remember which.

Great minds think alike.

Also the wackiest too!

Brown's Kitchen Supply, on Capital Circle NE, has larger size cutting boards. The piece in the picture is less than half the board I bought.

Ive got some scraps left over from the Maverick. Shoot me a pm if you still need some. Be glad to mail you a piece!