BigBendFishing.Net

Jack plate got stuck in the up position this morning. Need to get looked. Where to go?

If it's a Bob's try swapping the relays - If it goes down, the skinny is that it's a Mercury relay.

or carry it to:



or

What chalk said, or the switch could be bad on one side.

Dont't worry that the best place for it.

snatch-n-reel wrote:Dont't worry that the best place for it.

I didn't know you drink.

If it's not the switch, there is a bleed valve on the bottom of the ram..

i've been on a 22' boat with the jack plate all the way up and it ran in places that the taylorboat would not run.

snatch-n-reel wrote:i've been on a 22' boat with the jack plate all the way up and it ran in places that the taylorboat would not run.

I heard he couldn't run with the plate all the way up.

The Taylor boat would not want to run in most of those places.

update,
took the boat to Parkway at lunch. They told me that they would check it and give me a call at 12:45. They called at 4:36 all done. Wasn't expecting to hear from them until tomorrow or Wednesday. Thanks

Why didn't they call at 12:45?

Good folks.

Jumptrout51 wrote:Why didn't they call at 12:45?

b/c that's when I dropped it off. Couldn't ask for quicker service. Plus saved time and gas, not having to drive to the coast as I would usually do.