BigBendFishing.Net

Does anyone know any place around that I can get 2 sheets of 1/2" plywood 4' x 14'?

Thanks,
Ben

I believe you will have to scarf two pieces together

1/2" You building an ark

As RC said you will either have to scarf or butt splice two pieces together....butt splice with wood or fiberglass

Like this - http://www.jemwatercraft.com/forum/viewtopic.php?t=25

J.H. dowling may have it. madison st.

Thanks RC

Chalk wrote:1/2" You building an ark

Nope didn't think so, Need to go smaller?
3/8"?
Can I get that in a 14' section or do I still need to butt splice it together?
Sorry bout the questions, finally gonna try to build the little 14' jon boat I have been thinking about for a couple of years now.... Thanks for the help

My boat without fiberglass other than the sides was going to be 3/8"....I fiberglassed both sides and went with 1/4"

It depends on the design, horse power rating and construction. The design/designer really dictates the bill of materials. There are a couple of hundred wood john boat plans out there, if you don't have a basic set of plans I would highly recommend getting a set

http://www.unclejohns.com/jonboat/default.htm

Just remember, the plans are only good if you read them

Thanks for the info Chalk
The plans that I am looking at are supposed to end up like this so they say...


CM- KMA

KS preciate the number, Michiael at JH was very helpful and gave me 2 numbers to places that might have some will keep ya posted