BigBendFishing.Net

Just had some work done by Yancy at Gulf Coast Fabrications in Perry, Fl and was very satisfied with the quality and workmanship. If anyone is in the market for some Fab work, I would recommend them.

They did my T top, excellent work!!

Especially like the front one..what are the dimensions ?

Nice Jared! Looks real good.

If you don't mind me asking, what did the casting platform set you back? I've been looking for one.

Looks real good Jared!

Looks good Jared.Got to get me one of those casting platforms.

The front deck is 38" rear tapered to 26" in the front and stands about 14" tall. I have a little over $1000.00 in the both of them including two rod holders on the rear. My boat is probably too big to pole, but I am sure I will get more use than just a drink holder on the rear platform. I was thinking in general of several hot topless girls dancing on it at the White Trash Bash or something like that! There is always that chance...

LuckySOB wrote: I was thinking in general of several hot topless girls dancing on it at the White Trash Bash or something like that! There is always that chance...

Keep the faith, bro. If you build it, they will come.

LuckySOB wrote: I am sure I will get more use than just a drink holder on the rear platform. I was thinking in general of several hot topless girls dancing on it at the White Trash Bash or something like that! There is always that chance...

like the way ya think ...