Page 1 of 1
Standard sized hitch ball?????
Posted: February 14th, 2004, 4:37 pm
by Atticus
How big is the most common ball size for trailer hitches? I want to put one on my jeep b/c some family members gave me a hitch ball cover to put on my jeep, I had been wanting to have a ball back there just in case I had to tow anything, now I am confused as to which size would be appropriate. I don't tow anything as of yet, I just wanted to know in case I had to tow something, what would be the most common size????
All I have back there is the receiver, and the tounge thinggy, I need a bolt to hold that toung thinggy in place and a ball. What size would be the most usefull?
Posted: February 14th, 2004, 5:39 pm
by wevans
Posted: February 14th, 2004, 5:55 pm
by Chalk
1 7/8" or 2" balls......use the one wevans posted..it's the best of both worlds
Posted: February 14th, 2004, 6:02 pm
by Tom Keels
I have the one like wevans posted because my Jon boat uses 1 7/8 and the key west is a 2. If you had to get just one, get the 2.
Posted: February 14th, 2004, 6:40 pm
by Atticus
Thanks guys
Posted: February 14th, 2004, 7:24 pm
by Reel Country
2" and you can pull my boat.
Posted: February 14th, 2004, 7:39 pm
by Atticus
... and YOU can rebuild my engine block/tranny... sweeet
Posted: February 14th, 2004, 10:22 pm
by Waterdog
I tote all three, never know what I might find that needs towing...
1 7/8 - just in case
2 - Plastic boat (Logic) & Smoker
2 5/16 - Dad's boat
Posted: February 15th, 2004, 1:22 pm
by Sir reel
Atticus,
Don't know if your planning on using a bumper provided hole or having a bar installed but just a word of caution, if you are planning on using the bumper. Setting aside any issues of load capacitiy... just having the ball located a small distance further from the bumper gives you more clearance when turning in a tight radius. In other words it keeps the trailer hitch from contacting the bumper or gouging when turning hard.
(my .02)
I know it may be tempting for a LS to just use the bumper(avoiding the extra cost) so just wanted you to know about my experiences with the turning issue.
Posted: February 15th, 2004, 7:27 pm
by tin can
Sounds like you're very knowledgable about bumper hitches, SR. Bend somethin, did ya?
Posted: February 16th, 2004, 9:50 am
by Sir reel
TC.. you know dog gone good n well what my experience is based on!!
Posted: February 16th, 2004, 12:41 pm
by tin can
LOL!
Posted: March 1st, 2004, 6:41 pm
by Atticus
Here is what I have, take it easy on me SR because I used to live in NY and NJ...
I guess this shows some ignorance but I don't know what "using the bumper" means
Receiver-
Tounge, locking bolt and 2 inch ball-
Posted: March 1st, 2004, 7:57 pm
by Sir reel
Ya done good Atticus
but I don't know what "using the bumper" means
Some folks call em "step bumpers" it's where the hole for the ball is manufactured into the bumper its self.
