BigBendFishing.Net

My 40 hp Yamaha wants to not tilt up when it has been sitting. I usually have it all the way down when in the yard. When i am getting ready to leave I will raise it for the road trip. Tonight it was clicking but the motor was not engaging. I kept at it and finally it moved. When I pushed the switch for down the motor would run.
Once it is up, it wants to not operate downward for a second then the motor will run if I keep at it on the switch.

Anybody got an idea on what ails it?

Is this happening with the switch on the motor or the shifter?

The shifter

Corroded connections and or low battery.

Battery was just charged. Where are the connections I need to check?

Check the T&T motor for rust! Mine has rusted badly twice now, replaced under warranty the first time, but is getting in bad shape again now and works with a hope and a prayer

Battery connections are the probable culprit. Check all of them. Start by loosening them. Then clean with a wire brush or sandpaper, both the battery posts and the electrical connectors. Apply a good corrosion preventative or dielectric grease and reconnect. Be sure the wing nuts are good and tight.
Pay special attention to the negative connections.

Thanks everyone. I'll do it!