Page 1 of 1
Question about epoxy rod finish
Posted: February 16th, 2013, 3:22 pm
by Mister Mullet
Does cold weather affect how epoxy high-build rod finish hardens? Been waiting weeks for the weather to warm so I can finish a rod for an upcoming trip, and now I'm running out of time. Anybody? Anybody?
Re: Question about epoxy rod finish
Posted: February 16th, 2013, 4:40 pm
by dombern34
you will be fine. just apply the finish. at the worse it might take a little longer to cure. just leave the brush in the cup and after 12 hours. put your finger in the cup if it leaves a finger print its not ready keeping checking the cup until its fully cured. then you'll be ready to fish.
Re: Question about epoxy rod finish
Posted: February 16th, 2013, 5:18 pm
by charlie tuna
I wouldn't worry about temperature as much as dampness. The resin has cobalt which reacts and causes the epoxy to cure. I would finish the rod and bring it inside the house to cure.
Re: Question about epoxy rod finish
Posted: February 17th, 2013, 2:27 pm
by Mister Mullet
Thanks guys. Tomorrow's the day.
