Page 1 of 1
Metal Fabrication of Tallahassee
Posted: March 12th, 2013, 4:29 pm
by Badbagger
After getting some great recommendations here, I gave Chad at Metal Fabrication of Tallahassee a call and brought the green monster aka SeaArk to him. SeaArk builds one hell of a boat but, storage is lacking. I basically drew up what I wanted, marked up the boat and Chad & Company went to work. The results are outstanding and my hats off to Chad and his crew. If anyone needs any fabrication done no matter how major or minor, Chad is the man. I had extensive work done and I am very very happy
Re: Metal Fabrication of Tallahassee
Posted: March 12th, 2013, 4:48 pm
by guthooked
Can you post some pics
Re: Metal Fabrication of Tallahassee
Posted: March 12th, 2013, 6:54 pm
by charlie tuna
This is a SeaArk Tunnel hull which i compartmentized using ALL foam/fiberglass covered materials.
Everything goes below decks, batteries,rods,fish cooler,tackle, nets,boat gear,live well,fuel tanks,etc..
Re: Metal Fabrication of Tallahassee
Posted: March 12th, 2013, 10:40 pm
by Skeeter-Bite
Looks great! Good fishing!
Re: Metal Fabrication of Tallahassee
Posted: March 13th, 2013, 5:46 am
by SS-342
Bb: Sounds like you have put togather one heck of a fishing boat! Congratulations!
Re: Metal Fabrication of Tallahassee
Posted: March 13th, 2013, 2:01 pm
by Badbagger
Thanks, I'll get some pics together of the fabrication. I just got in from an 11 hour drive to Sarasota and back. Having my buddy Linex the interior of the hull and paint the exterior.
Re: Metal Fabrication of Tallahassee
Posted: March 13th, 2013, 3:01 pm
by guthooked
That looks great.
Re: Metal Fabrication of Tallahassee
Posted: March 13th, 2013, 3:51 pm
by Badbagger
Rather than just toss up a few pics, here's a link to my build on tinboats.net - It's got it all from the start up through dropping the boat in Sarasota today.
It's going be to be couple or 3 weeks until the linex and paint is done.
Have a look if you're curious:
http://www.tinboats.net/forum/viewtopic ... 21&t=29196