BigBendFishing.Net

I am in Tallahassee. sorry about the poor grammar and forgetting all the info needed in post. am new to posting. will get the hang of it.

Welcome aboard wareagle -

JumpTrout is your go-to guy for appliance repairs. Heard of him fixin ice machines too.

anybody know how to get ahold of jumptrout. or if jumptrout sees this give me a call. 519-8546.

wareagle wrote:I am in Tallahassee. sorry about the poor grammar and forgetting all the info needed in post. am new to posting. will get the hang of it.

No need to apologize, your user name explains a lot!

that is the kind of boat I have juan.

What brand of ice machine and what is your issue?

it is an ice-o-matic. it is having an issue where it goes into ice harvest mode to often. like every 2 minutes or so. water has always worked then I went out there today and the water was not flowin. don't know much about ice machines.

Juan wrote:

wareagle wrote:I am in Tallahassee. sorry about the poor grammar and forgetting all the info needed in post. am new to posting. will get the hang of it.

No need to apologize, your user name explains a lot!

Oh no you didn't!

I need a model number to be specific.
But,on iceomatic the harvest cycle is controlled by refrigerant pressure drop.
Poor or no water flow can cause a quick drop.
The water supply,water pump and water distribution tube must be checked and cleaned.
The water dump valve may be leaking water out during the freeze cycle as well.
If all these are checked and corrected there is possibility of a refrigerant leak or faulty low pressure valve.
Do the 2 refrigerant lines entering and leaving the evaporator ice over?
Is the machine perfectly level?

You forgot to ask the really important question Steve "Do you have plenty of beer, if he comes over to fix it?"

hey jumptrout. lost your phone number. wandering if you could give me a holla.

I wouldn't put my phone number on the Internet, to many crazies, cons, etc. use the PM (private message) function of the forum to send it to him. I would edit your post and remove it after sending the PM.