Anyone have the Knack - Chainsaw Tuning
Posted: February 15th, 2014, 11:01 am
I had a split primer bulb on my Poulan PP4218 and replaced the bulb. When taking it apart, I may have mistaken the idle speed screw for one that needed removed to get the pull cord assmbly off.
Now the dang thing won't keep running...
Yes I've screwed with the screw, put new gas in it, made sure the fuel lines were in place but it just doesn't keep running.
I (and my neighbors) would like to get this solved so I can finish up the tree that fell Christmas.
Any suggestions or recs on someone who can tune this thing?
(I guess I could take it up the hospital for JT to play with but...)
If anyone knows the starting position of the idle screw ( how many turns out ) that would help.
Now the dang thing won't keep running...
Yes I've screwed with the screw, put new gas in it, made sure the fuel lines were in place but it just doesn't keep running.
I (and my neighbors) would like to get this solved so I can finish up the tree that fell Christmas.
Any suggestions or recs on someone who can tune this thing?
(I guess I could take it up the hospital for JT to play with but...)
If anyone knows the starting position of the idle screw ( how many turns out ) that would help.
Mine had the same symptom and a dirt dobber had stopped up the exhaust 
