BigBendFishing.Net

I have a 20' aluminum bay boat (Xpress) and need to install a cleat on the bow to tie off an anchor. This will be used on lakes and bays in AL, GA, FL; not offshore unless its very calm. I have limited access underneath the deck. I'm looking at a model 331 Quick-Cleat.http://www.quick-cleat.com/series-300-f ... 3-8-lines/ Would this be suitable? There is also a Cam Cleat that I'm looking at. Other than those two, I could get a fold-down or pop-up cleat. I will welcome your comments.

Those should work fine. You probably want to rubber in between the steel and the aluminum to cut down any oxidation issues between the two metals.

ugadawg wrote:Those should work fine. You probably want to rubber in between the steel and the aluminum to cut down any oxidation issues between the two metals.

I agree!!


Sent from my iPhone using Tapatalk