Page 1 of 1
Offset seat post?
Posted: November 27th, 2020, 10:19 am
by bman
I need to swivel the back seat in my duck boat 3-4 inches toward the center when I’m hunting.
The seat is flush with a typical Atwood pin mount.
This would work of the pin was on the opposite side.
- 263623CD-B68E-4FB7-81B7-2FD862AF8B28.jpeg (26.29 KiB) Viewed 2577 times
I guess I could take it to a welder but does anyone have another idea?
Re: Offset seat post?
Posted: November 27th, 2020, 10:24 am
by MudDucker
You can get them the opposite way. I have a couple I use.
Re: Offset seat post?
Posted: November 27th, 2020, 1:45 pm
by bman
I cant find them on line....
Re: Offset seat post?
Posted: November 28th, 2020, 8:05 am
by MudDucker
Hmmm, I've had mine about 10 years, but I don't see them online either.
You might have to get it customized. Be sure the bushing on the pin is big enough that the arm doesn't scrape your boat when you rearend is in the seat.
Re: Offset seat post?
Posted: November 28th, 2020, 9:01 am
by fishinfool
Re: Offset seat post?
Posted: November 28th, 2020, 10:05 am
by bman
Saw that one... it’s going to sit me up too high
Re: Offset seat post?
Posted: November 28th, 2020, 10:07 am
by silverking
Metal Fabrication of Tallahassee could make one to your exact specs.
You might also check with West Marine and Overtons on-line.