BigBendFishing.Net

I want to add a couple of rod holders near the bow on the bay boat and can't find the style I need.. They're going to be mounted in corners and the single PVC rod holders are a good fit but I don't want the PVC ones. I thought I had seen the same style holders in stainless steel but don't remember where I saw them and can't find them on the web. Anyone know where I can find the stainless steel holders?
Like this but stainless:

found a pair on ebay for 41 bucks

I can't find em there. Gotta link?

Birdsall Marine

I found these, similar but not exact:
https://www.amazon.com/Amarine-made-Fis ... B00N8K0IH4

https://hotstuff4fishing.com/products/a ... ets-2-pack

https://www.anchorexpress.com/Tigress-S ... jAQAvD_BwE


Search “single surface mount stainless steel rod holder” for more of the same.

Thank you. I had looked at those and because of the mounting bracket style I don't think they will fit into the corners where I want them. I may have to pick another location.

Found a couple that might fit your needs,

https://www.boatoutfitters.com/transom- ... _wcB#93=17

https://www.amazon.com/SEACHOICE-Holder ... B000N9HPDI

https://www.boatid.com/seasucker/seasuc ... 11472.html

Check out the ( bay-sun store on ebay)

Have you considered flush mounted holders? That’s the way I’ll eventually go.

Salty Gator wrote: ↑November 10th, 2021, 10:07 am Have you considered flush mounted holders? That’s the way I’ll eventually go.

I initially considered flush mounts David but the way the hull is sloped, they won't fit anywhere except over a rod box or storage compartment and I don't want that. I'd have bet money I had seen the exact style of the PVC holders in stainless steel but maybe I'm wrong. I may have to buy a stainless steel triple rod holder and center it on the storage box but I really want to put them in the corners if possible.

I wonder if you could bend the tabs on this one to fit in the corner?

https://www.amazon.com/SEACHOICE-Holder ... B000N9HPDI

ropeman wrote: ↑November 10th, 2021, 1:48 pm I wonder if you could bend the tabs on this one to fit in the corner?

https://www.amazon.com/SEACHOICE-Holder ... B000N9HPDI

Thanks but I looked at that option too and I think if I bent the brackets, the angle would make it impossible to get to the mounting holes.

Here is one out of aluminum, may work depending on how you are going to bolt it in.
https://www.boatoutfitters.com/rod-hold ... hite-liner

leonreno wrote: ↑November 11th, 2021, 1:21 pm Here is one out of aluminum, may work depending on how you are going to bolt it in.
https://www.boatoutfitters.com/rod-hold ... hite-liner

I can make those work! Great find. Thank you!!