Page 1 of 1
trolling motor question
Posted: July 4th, 2005, 2:10 pm
by Eerman
Ordered a 24 volt bow mount Minn Kota for the boat the other day. Unfortunately, won't be here for a few more days. I was wondering if you guys had any hints or suggestions for installation. Particularly, what size wire have you guys used on yours and did you guys use any circuit breaker? If so, what size circuit breaker? Any other suggestions are welcome.
Posted: July 4th, 2005, 3:03 pm
by rocket
Mine came wired, but it looks like a jam up job, w/ circuit breakers on each battery, onboard charger, etc. You're more than welcome to take a peek if you like. I'd hate to try to tell you any info 'cause I'd probaly get it wrong!
Posted: July 5th, 2005, 11:57 am
by Jumptrout51
use 10 gauge wire and 30 amp fuses(one from each battery's hot side)
Posted: July 5th, 2005, 12:03 pm
by dbplug
I have a 24V bow mount MK, you are welcome to take a look. I live in NE Tally near I-10.
Posted: July 5th, 2005, 12:38 pm
by RC
10 ga. is good. I recommend a tinned marine wire. I like a circuit breakers rather than fuses. I use a 40 amp circuit breaker at the battery on the hot lead. Look at your owners manual. It will tell you what size breaker. If you use fuses carry spares.
Posted: July 6th, 2005, 6:19 am
by tin can
Most boats are pre wired with 6 ga. wire. Cuts down on line loss between the batteries and the trolling motor. 30 anp breakers are sufficient. As RC stated, use marine grade wire.