Tilt problems
Moderators: bman, Chalk, Tom Keels
-
- Posts: 15
- Joined: November 13th, 2011, 7:27 pm
Tilt problems
I have a yamaha 40hp and when I press the up or down tab all I hear is a clicking sound. Does this mean that the switch is ok but something might be wrong with the connections or hydrualic pump motor?
-
- Site Sponsor
- Posts: 12120
- Joined: December 12th, 2001, 8:00 pm
- Location: Tallahassee
-
- Posts: 6065
- Joined: December 26th, 2004, 2:36 pm
- Location: CAIRO,GA
Re: Tilt problems
IT COULD MEAN THAT YOU HAVE A LOOSE CONNECTION, PROBABLY THE GROUND WIRE. DISCONNECT ALL OF YOUR WIRES TO THE TRIM AND SAND THEM DOWN TO BRIGHT METAL AND PUT THEM BACK AND TIGHTEN THE NUTS REAL TIGHT, THEN GIVE IT A TRY, IF IT DOES NOT WORK , WHAT JT SAID WOULD BE THE NEXT AVENUE TO TAKE.
PA
SEMPER FI
PA
SEMPER FI
FUTCHCAIRO
-
- Posts: 15
- Joined: November 13th, 2011, 7:27 pm
Re: Tilt problems
Thanks for the information, I'm going to get the situation solved this weekend so I can get back to fall fishing.
Re: Tilt problems
Does the motor turn over?
-
- Posts: 15
- Joined: November 13th, 2011, 7:27 pm
Re: Tilt problems
It turned out to be the hydraulic motor......rust had eaten into it and caused a short I supppse. Mike's Marine in Panacea is going to replace it, they are just waiting for a new one to arrive.