My troy built mower is giving me problems. Normally it will barely turnover when I first hit it. I usually have to charge the battery a little to get it cranked. Yesterday, same thing. I get on, turn the key, it turns over a couple of times and the battery is dead. So, go get a new battery (I've needed one for a while), hook it up, now nothing.
I can turn the key and hear the fuel pump click and the solenoid engage, but nothing happens. I can jump the solenoid and the starter will turn, but the bendix will not engage the flyweel, in fact, I cannot even make it do so with a screwdriver. I have checked the fuses and they are fine. When the key is on, there is a small red wire in the wiring harness next to the engine that gets hot to the touch. I cannot see where that wire terminates on the engine because it goes up under the flywheel. I can only assume since this wire is getting hot, that it is probably the cause of the issues.
Also the headlights nor the backup override lights do not light up when the key is on.
Anyone have any ideas? Taking it to the shop will be a chore since it's in the shed in my back yard and I really don't want to push it all the way to the front.
Need some lawn mower help
Moderators: bman, Tom Keels, Chalk
- Tom Keels
- Site Admin
- Posts: 4044
- Joined: December 11th, 2001, 7:00 pm
- Location: Tallahassee, FL
- Contact:
Need some lawn mower help
Tom Keels
Site Founder

Site Founder

Re: Need some lawn mower help
Disconnect the starter wire at the starter and see if the wire gets hot
My first impresion is that the starter was the problem to begin with "or become so do to the weak battery"
if that don't do it, try disconnecting the hot wire going to the solenoid and see if the wire gets hot 
“Before you criticize someone, you should walk a mile in their shoes. That way when you criticize them, you are a mile away from them and you have their shoes.”


- Tom Keels
- Site Admin
- Posts: 4044
- Joined: December 11th, 2001, 7:00 pm
- Location: Tallahassee, FL
- Contact:
Re: Need some lawn mower help
Done figured it out. Solenoid is bad. I can jump it and it will start like a champ. I had to "engineer" a brake holder so I could start it while I wasn't sitting on the seat. Got a solenoid coming this week.
Tom Keels
Site Founder

Site Founder

Re: Need some lawn mower help
Tom, I'm glad you figured it out. I was writing you now to tell you to try replacing the solenoid. I replaced one on my Sears mower a while back for a similar problem. Happy mowing!
Yours in the South
-
What a mess
- Posts: 1570
- Joined: October 2nd, 2006, 8:35 pm
- Location: Valdosta Ga.
Re: Need some lawn mower help
Who needs a soliniod if it jumps save the $ & go fishen.
Yesterday it was taboo today it is normal what the heck will they be doing tomorrow?
- Tom Keels
- Site Admin
- Posts: 4044
- Joined: December 11th, 2001, 7:00 pm
- Location: Tallahassee, FL
- Contact:
Re: Need some lawn mower help
Well it's a $15 part and it's sort of a pain to jump it since it has a brake safety switch.
Tom Keels
Site Founder

Site Founder

