Go to carefully chisel the old transducer off and find removal from the bilge area (about 8" by 12") is a much tougher job than was the original installation
... being extremely careful and with much cursing and acrobatic fanfare, I did manage to get the old puck off as well as the vast majority of epoxy I used. Despite using great care I did chip a bit of paint off the area where the puck was glued down and I want to put my new puck in the same spot, though I may put a wet box in to house the new puck so I can swap out with less pain in the future.Know I need to sand the fiberglass smooth before putting wet box in, but don't know what kind of protective paint I should use to reseal the exposed fiberglass. Any & ALL advice on painting/resealing the fiberglass will be greatly appreciated!
BBG
