SOLD
Moderators: bman, Chalk, Tom Keels
Re: 1993 90 HP evinrude for sale
Or just read this "much easier Salt" 
Power trim and tilt comes with side mount controls and wire harnes, tach and tilt switch. No prop.
Had the motor for 4 1/2 years now with no problem till crap got in my carbs ( see prev. posts ) my dad died last month and my grand father left me a couple bucks payable to me apon my dads death and I am going to buy a new motor! So the motor needs a carb job . It runs but ya gotta keep working the chock. Bla bla bla . Tri state marine ( here in talla. say 400.00 will do it) That includes going thru the motor, electrical system and all that. I do know that one cylinder is lower in comp. than the rest but it runs fine. Had a new water pump and all new lower unit seals replaced 2 years ago as well as a new starter and power trim and tilt motor both from SOS marine ( here on the forum ) and I hooked it to the hose after EVERY use . I live about twenty feet from my boat ramp so its been well taken care of. The skeg got a chunk taken out of it while backing it up to the house
( I can be stupid ) I have the piece of skeg that fell off . That was 6 months ago. I was gonna have it welded back on but the fishing was to good and it didnt seem to efect any performance.
So there ya go one 1993 90 hp evenrude that needs carbs cleaned for sale.
Engine NEVER let me down. $900.00 still on the boat. PM me
“Before you criticize someone, you should walk a mile in their shoes. That way when you criticize them, you are a mile away from them and you have their shoes.”
-
Salt Life
- Posts: 267
- Joined: January 25th, 2006, 11:15 pm
- Location: I come from where the river meets the sea Live Oak Island
- Contact:
Re: 1993 90 HP evinrude for sale
Cool. Well done thanks . Sorry dont know all that fancy stuff !
BE GOOD AND FISH OFTEN