Shake Down Cruise 3/2

Use this area to post inshore fishing reports from the area. Please try to include relevant information such as:
Location, date, time, water conditions, weather conditions, baits, techniques, species caught, etc.
Image

Moderators: bman, Chalk, Tom Keels

Post Reply
Charles
Site Sponsor
Posts: 1441
Joined: December 30th, 2001, 8:00 pm
Location: Wakulla County, FL

Shake Down Cruise 3/2

Post by Charles »

Started thinking about the Endura 46 I've had sitting in the shed from back when I put the Redfishing Machine together. Went down Tuesday, registered the canoe and bought numbers. Yesterday afternoon I put the numbers on and made sure the battery was charged (remember this, it gets important later).

This morning I drop the canoe in the water at Wakulla Beach and start heading out to the vincinity of the south side of John's Island. Found out a couple of things right away. I had set up the motor to mount on the bow of the Redfishing Machine. With me, the motor and the battery in the bow of the canoe, it doesn't handle for diddly-squat, all I could do is kind of crab more or less sideways. Drifted while I pulled the motor up in the boat, whipped out my handy-dandy Leatherman Super Tool and got the head of the motor turned around without dropping anything in the bay. Moved the motor and battery to the stern which proved to be a much better set up. Humming along I started thinking that this was so easy it would be an easy way to get in trouble by getting too far to get back if the weather kicked up (remember this, it gets important later).

Got aways south of John's Island, to get around the flat at low tide, and hummed around looking for a natural channel that I knew was there, but didn't have numbers on. Finally found it. Now the breeze is beginning to pick up and the tide has started in allowing me to drift, if somewhat fast, along the edge of the channel. Picked up a few small trout doing this and one keeper on a Catch 2000. Had a pawl go out on one of my reels, glad I had two spare rods with me. By the time I got to the east end of the island the wind has started to pick up noticably and started to put a chop on the bay. I drift a little further and decide to try West Goose Creek.

As I'm heading for West Goose Creek across the chop, I notice that Graves is much closer. Not only that, but by now it's choppy and windy enough that my brand new numbers are coming off. I notice this when I see a "1" blow across the bow. :-?

Made it to Middle Creek with the wind and waves at my back and the feeling that the motor just didn't seem as torquey as it did when I first started out. Oh well, I primarily only want to try one bend in this creek for about an hour and then it'll be time to start heading for the house.

Got to the bend I wanted to fish and threw the anchor right up in the marsh so the canoe would lay off right along the bank. Hoping for a red, I picked up a nice 21" trout and then a 19, but no reds. Tried the next bend up and caught nothing at all there.

Now it's time to head for home. I make it out to the mouth of Middle, the motor is definately lagging and the water is rough. Oh well, it's not far to the landing. Get to the point near the mouth of Graves. The tide is rippin' around this point and the wind is whippin' and I'm barely making head way. Pick up a paddle and start helping the motor. This is working and we're doing okay as long as we keep the bow almost into the wind. Let the bow fall off the wind and it's a huge fight to get it back before the wind puts the boat in the marsh. Make it around the next point, before you get to the fence, and the battery is now completely dead. I can't handle the boat solo in this wind without help from the motor, so I just let the wind land the boat against the grass. Time to change from the rubber boots to the wadin' shoes, we're walkin'.

By now the tide's high enough to have the grass flooded. Pretty easy walk, much easier than paddling under these conditions. Some big mullet up in the flooded grass, but not bunched up and the waves have the water so muddy I can't see them. Took a castnet with me primarily for ballast, now I break it out. I'm pushed for time getting home, but I try a few blind casts and come up with one nice mullet to go with the three keeper trout in the cooler.

Thoughts and Observations
Was the battery only partially charged? I charged it before I put it away, but it's been sitting in the shed for months. The meter on the charger said it was charged. Seems like it used to run a lot longer on the Redfishing Machine, but then I wasn't covering as much distance in a trip and I wasn't running it on full power. It'll be fully charged next time. It's on the charger now, recovering from cold, stone, dead.

In a canoe, a paddle's helpful even if you have a motor. So are wading shoes.

Need to get longer cables on that motor so I can run the boat and fish without having the battery between my feet. It would also be helpful in trimming the boat to get the battery further foreward.

Having the motor clamped to the side of the canoe, behind the aft seat, is not as in the way for paddling as I thought it would be. It's in the way a little, just not as bad as I thought and the canoe manuevers pretty good with it back there.

The jury's still out on whether having the motor on the canoe is really an asset. Today I think I'd have been better off with a sail.
User avatar
rocket
Site Sponsor
Posts: 3165
Joined: May 2nd, 2002, 8:00 pm
Location: MODERATOR

Post by rocket »

Good report CP...did those trout look like they had been eating good, or were they hungary? :D
Charles
Site Sponsor
Posts: 1441
Joined: December 30th, 2001, 8:00 pm
Location: Wakulla County, FL

Post by Charles »

They were hungry, but they ate good. :D

Another problem I ran into was, in order to take advantage of the 360 degree steering, the motor had to stick down so far below the bottom of the hull it needed as much water as a jonboat the same size, maybe bigger.
User avatar
mjsigns
Site Sponsor
Posts: 4918
Joined: June 8th, 2004, 10:14 pm
Location: Tallahassee

Post by mjsigns »

Charles-

Good Report- you must have a large canoe to be able to haul you, the battery and the motor in the stern. My canoe wasis only 14' and it's not made to carry a motor or battery. You must have bee riding awfully low in the rear with all that weight in the stern. I got swamped a few times around the lighthouse, and blown about by the wind many times (10-15 yrs ago) and I know it can get ugly real quick in a canoe. sounds like you played it smart and stayed tight to the shoreline most of the time :thumbup: I'm not an expert battery guy, but I always charge my battery 24-48 hours prior to an outing. Might be new battery time. Take it wo battery source (or any garage) and they'll check it for free. I should be throwing at least 600 cranking amps if it is still a good marine deep cycle battery.

Good catch!
Time is the most precious commodity we have in life, stay focused.
Charles
Site Sponsor
Posts: 1441
Joined: December 30th, 2001, 8:00 pm
Location: Wakulla County, FL

Post by Charles »

Both my canoes are Old Town Guide 147s. 14'7" long with a beam of 38" is a wide canoe particularly for this length. They have a weight capacity of 900 lbs.

When I'm solo, I load my gear to trim the canoe to keep the full length of the boat in the water. This gives me the stability to stand up to fish. Which is also why I like a longer paddle than what would normally be considered right for me, so I can paddle standing up.

I just got this battery last, September I think it was, I hope it hasn't gone bad already, I haven't used it much. I'm thinking, hoping, it was a combination of not being fully charged after having sat in the shed for so long and running the motor harder and longer than I have when I used this battery before. I put it on the charger after I got home yesterday and this morning the meter says it's not quite fully charged. Checked the water and cleaned the terminals. I'll try it again and if it still seems short lived, I'll take it and get it checked. If they tell me it's okay, I'll just chalk it up to expecting too much of it. It's an Interstate Batteries, Marine/RV, Deep Cycle, 600 CCA, 750 MCA.
User avatar
Sir reel
Site Sponsor
Posts: 6206
Joined: January 22nd, 2003, 11:35 am
Location: Tallahassee

Post by Sir reel »

Charles...that was a super job of working the conditions and get'n it done with what you have to work with :thumbup: . Outstanding job of reporting as well.... your well placed
(remember this, it gets important later).
had me grin'n before I even knew for sure what was coming. Glad you got some fish for your trouble.... we'll keep our eyes peeled for a #1 float'n around out there :D
"Good Judgement" comes from experience, ... and a lot of that..... results from "Bad Judgement".
Charles
Site Sponsor
Posts: 1441
Joined: December 30th, 2001, 8:00 pm
Location: Wakulla County, FL

Post by Charles »

There's four 1s, one 2, one N and one C out there somewhere. :x

Think I'll just make some numbers out of strips of Gorilla Tape. If that doesn't work, I'll paint them on. If that comes off I'll be having bigger problems than lost registration numbers. :o
User avatar
dstockwell
Posts: 4214
Joined: March 5th, 2002, 8:00 pm
Location: Valdosta, GA

Post by dstockwell »

Great report, good job. :thumbup:
Post Reply