Help on Flats Jack jack plate

Post by **Fish Masterson** » March 27th, 2006, 10:28 pm

A buddy of mine has a flats jack and one of the solenoids has stopped working on it so it has ceased to operate. Do any of you gurus, have any idea where a replacement part can be found, and exactly what the part might be called.
Thanks, Fish Masterson

Post by **Jumptrout51** » March 27th, 2006, 10:33 pm

I would have to see it.

Post by **Sea Dawg** » March 27th, 2006, 11:15 pm

the solenoids that controls the jackplate is the same as a trim and tilt solenoids ,,they are high and he will keep haveing trouble with them if are not placed where the salt water can't get in them i have a cooks jack plate and have changed a few of them .Then i got Mr Porter at Poters marine to change the ome out for a new kind and Mount them under the cowling on motor haave never had any trouble sense

Post by **snook** » March 27th, 2006, 11:31 pm

if its a bobs machine shop system, the switch itself may be the problem..there cheap and easy to replace...just cut the the switch wires and find the common...try just putting the bare wires together one thaan the other...

Post by **Fish Masterson** » March 28th, 2006, 8:40 pm

Thanks for the information guys. I will pass it along.