SOLD!

Post by **MudDucker** » May 25th, 2006, 10:04 pm

I've got a single axle aluminum boat trailer for up to at least a 20 foot boat for sale (might could put a 21 on it). It has just had the springs and hubs replaced in the last 60 days. $650 with boat on it or $750 without boat.

It also has an electric winch on it and a free 1970's 20 foot proline flats project boat sitting on it now.

Post by **captainspride** » May 25th, 2006, 10:09 pm

do you have a picture

Post by **MudDucker** » May 30th, 2006, 6:37 pm

Aya and when I get back from Maine, I'll send you some.

Post by **MudDucker** » June 12th, 2006, 3:38 pm

Here are some pictures of the trailer, along with pictures of the free 20 foot proline project boat. If you only want the trailer, I can arrange to have the boat removed. The motor is gone.

Since these pictures were taken, I've had new springs and new hubs put on the trailer.

cmatt · Post by **cmatt** » June 16th, 2006, 8:37 am

I sent you a message about the boat and trailer.

AFrayedKnot · Post by **AFrayedKnot** » June 21st, 2006, 4:42 pm

Interested in the boat and trailer. Let me know if it is still available. Thanks.

Post by **MudDucker** » June 22nd, 2006, 10:18 pm

Yes sir, they are still available unless cmatt beats you to them. They are located at Valdosta Outboard. Its is right off of the N. Valdosta Rd exit of I-75. Take a right at the first light and it is down on the right about 1/2 mile down the road.

AFrayedKnot · Post by **AFrayedKnot** » June 23rd, 2006, 9:09 am

Thanks MD. How would I make arrangements to see it? Is the gate at Valdosta Outboard open? Is it possible to see it Saturday early AM? Thanks.

dstockwell · Post by **dstockwell** » June 23rd, 2006, 2:52 pm

There is no fench at VD outboard, or at least not since the last time was there.

Post by **wevans** » June 23rd, 2006, 7:26 pm

You talkin Californi talk again Don

Post by **MudDucker** » June 23rd, 2006, 9:56 pm

Don right, there isn't a fence. They are open until noon or a little after on Saturday.

AFrayedKnot · Post by **AFrayedKnot** » June 30th, 2006, 3:21 pm

MD-Is the trailer (and boat) still available? Thinking about making a run up there over the weekend. Thanks.

Post by **MudDucker** » June 30th, 2006, 3:48 pm

Yep, it is still available.

cmatt · Post by **cmatt** » June 30th, 2006, 9:05 pm

I went down Wed and looked at it. The boat look like a good project. The trailer fender bracket on the passenger side needs to be welded back on. I liked the lines of the boat. I might be interested if you make me a real good deal!

Post by **MudDucker** » June 30th, 2006, 11:21 pm

Hmmm, the last time I saw it, the fender bracket had been welded back on. I'm below my cost now...how good of a deal do you need?