Reel Maintainance

This area is for general discussions about fishing, rigging, baits, etc.
Image

Moderators: bman, Tom Keels, Chalk

Post Reply
pops
Site Sponsor
Posts: 418
Joined: May 6th, 2002, 8:00 pm
Location: Monticello, FL

Reel Maintainance

Post by pops »

What is the best oil or grease to use in your reels?
GO GATORS!!
If it does not meet your standards, Lower your standards!!
User avatar
Chalk
Moderator
Posts: 9550
Joined: March 9th, 2002, 7:00 pm
Location: 30° 13' N, 85° 40' W
Contact:

Re: Reel Maintainance

Post by Chalk »

pops wrote:What is the best oil or grease to use in your reels?
It should read best oil and grease, not one or the other.... Pawls and worm type gears like grease, oil on bearings and other moving parts.

I use the following oils, 3 in 1 (actually read report and it is in the same class as the exotic reel oils), Rocket Fuel, Quantum Hot Sauce and ABU Garcia.

For grease, I use the Abu Garcia grease and Shimano grease.

Not enough or too much of either one is a bad thing, use both sparingly
FUTCHCAIRO
Posts: 6051
Joined: December 26th, 2004, 1:36 pm
Location: CAIRO,GA

REEL MAINTENANCE

Post by FUTCHCAIRO »

I USE ABU GARCIA OIL AND GREASE AS WELL AS TAKE A CAN OF W-D 40 AND SQUIRT A LITTLE ON THE WORM AND PAULS WHILE FISHIN.
PA THE OLD MAN OF THE SEA
FUTCHCAIRO
Charles
Site Sponsor
Posts: 1142
Joined: December 30th, 2001, 7:00 pm
Location: Wakulla County, FL

Post by Charles »

The rule of thumb I follow is:
If it moves or spins during casting it gets 3-in-1 Oil.
If it moves or spins only during the retrieve it gets Le Tour Weather Proof Grease. A lithium based waterproof grease supposedly designed for bicycle bearings, but does a very good job on reels. Unfortunately my source for this stuff burned to the ground and it doesn't look like they're coming back. :smt010
http://www.branfordbike.com/
User avatar
tin can
Site Sponsor
Posts: 10124
Joined: May 6th, 2002, 8:00 pm
Location: Tallahassee, Florida

Post by tin can »

Been using 3 in 1 oil for 35 years with no complaint. I use either ABU or Shimano grease on the worm gear, and drive gears. It works better and doesn't gum up as bad if you thin the grease with a little bit of 3 in 1.
What was I supposed to do today?
Post Reply