Mechanic's Ideas ?

Post by **mjsigns** » July 11th, 2007, 1:03 pm

Thanks Again Guys -

I told him I could wait a while since the boat & motor are at auction at Ebay:
I think the Cash idea would work, however, I will have to wait till I have the ca$h and wait till he is motivated to $ell the motor.

This guy seems "green" as far as selling marine boats & motors. Ebay records indicate he started selling on ebay on 12/2006...

I'm going to adopt a "wait and see" method on this seller and motor.

Thanks !

dowawoo · Post by **dowawoo** » July 11th, 2007, 10:23 pm

I had a evinrude that did that, and I spent alot of time on it till I pulled the head and found that one of the pistons had broke a ring and was scuffing the cylinder really bad..ended up tearing it apart, took the power head in and had it rebored and all the cylinders honed and bought a new piston and rings , RR all that, put it back together and it ran fine , that was three years ago and its still going, I no longer own it, but the guy that does swears by it...if I were you, check those pistons....
don

chugbug · Post by **chugbug** » July 12th, 2007, 10:09 am

If you had water in that cylinder, more than likely you blew a head gasket. Again, a compression check will verify that. Good luck with your search for an engine.

dowawoo · Post by **dowawoo** » July 12th, 2007, 5:19 pm

Don't know if this will help , but found this on the FS site...
(johnson 1985 90 hp runs lower unit good ss prop 20" shaft tilt and trim working wiring harnes call bill 9547715515 need to move need space)