Good outboard mechanic?

Post by **Redbelly** » October 1st, 2006, 5:57 pm

To work on a Nissan? I want to get it looked at, wants to idle a little rough, or not at all.

Post by **MudDucker** » October 4th, 2006, 11:06 am

James Dean, Valdosta Outboard.

Post by **bman** » October 4th, 2006, 11:28 am

I have had good work done by Websters Marine.
They are between Tallahassee and Havana.

They are a Nissan/Tohatsu dealer.

Webster's Marine Svc
(850) 562-1052
996 Fl Ga Hwy # 27
Havana, FL

Post by **Redbelly** » October 4th, 2006, 5:21 pm

Thanks, I was thinking of Webster.

Hit-n-Miss · Post by **Hit-n-Miss** » October 5th, 2006, 7:58 am

Have you tried running a tank with SEAFOAM through it . It cleared my rough running right up. :thumbup:If not there is a nissan deler in Adel.

Post by **Redbelly** » October 5th, 2006, 7:30 pm

I have considered seafoam.

Post by **Redbelly** » October 16th, 2006, 7:15 pm

Hit n Miss do you just add it to your tank and run a few treated galons through?

I have read on another boating forum where there is a blast method, using a concentrated amount.

I think I will follow the instructions.