BigBendFishing.Net

I've been having a problem with the trolling motor speed control recently. Well after doing lots of troubleshooting I found out
that there was a short in the Unit itself and not in the cable or anything else. The only bad part is, I found out about this, because my trolling motor
caught on fire Sunday So needless to say it's off to Minn Kota here I hope shortly...

mojokoko wrote:because my trolling motor
caught on fire Sunday So needless to say it's off to Minn Kota here I hope shortly...

There must be something to this hex JT51 is putting on folks. Hate to hear about it.

HEX what HEX.
Sorry about your problem.

Jumptrout51 wrote:HEX what HEX.
Sorry about your problem.

You know - when I won that fish scaling device with built-in hose (thanks to South Georgia Outdoors) in the raffle two meetings ago, JT said something about it being a shame it was going to someone who can't catch fish. I have only caught one keeper red since then I think, and it had prop scars in it to the extent I'm surprised it was alive so it was very carefully released...you tell MEEEE what hex JT...

That's at least three trolling motors that went down during the tourney...he's up to something folks...watch him veerrrry carefully.

You can buy a MF brand pushpole at Jerrys Bait and Tackle.
We have one and used it Saturday. Works when the TM won't.

Jumptrout51 wrote:You can buy a MF brand pushpole at Jerrys Bait and Tackle.
We have one and used it Saturday. Works when the TM won't.

So does a paddle or a somebody pushing.