BigBendFishing.Net

Hey guys, my poling platform has cracked in three spots at the top, right below the platform. I was hoping that one of you could point me in the right direction for a fix? Its a aluminum platform.

Thanks, Carson

Waviel Porter at Porters' Marine,Woodville.
When he repairs it, it may crack someplace else,but not where he repairs it.

Of course, T-Top Guy (Gulf Coast Fabricators) is bound to do a good job, too.

Glenn at Skinny Water Products in Woodville can do it too.

Waviel Porter at Porters' Marine,Woodville. is your best bet for your money ..

Thanks! Calling Waviel in the morning.

Don't forget about BigBendFishing.Net sponsor Gulf Coast Fabricators

Harmsway wrote:

Of course, T-Top Guy (Gulf Coast Fabricators) is bound to do a good job, too.

Chalk wrote:Don't forget about BigBendFishing.Net sponsor Gulf Coast Fabricators

Sea Dawg wrote:Waviel Porter at Porters' Marine,Woodville. is your best bet for your money ..

Ouch!!!

And to think, I was going to do it for free.

Zing!

I can vouch for The Gulf Coast guys. You should see the welds in the Alum. he did for me on a roof mounted rod tubes. After a year plus on the top of my truck and in the woods hitting over hanging limbs, not a crack in the welds yet.