Page 1 of 1
Center Console Seat and Screws Striped problem.
Posted: April 2nd, 2006, 4:55 pm
by mojokoko
Well I went and checked my boat because I knew the Center Console seat was a little loose. It appears as if the screw holes have been striped so to speak and or I just done have them centered right. Do any of you guys know how to fix a problem like this?
Posted: April 2nd, 2006, 6:03 pm
by Charles
What I would do, and I'm not saying either of these ideas are the right way to go about this, is use a larger diameter stainless steel screw.
The other, and probably most likely thing I would do, is put Gorilla Glue on a couple toothpicks, insert them in each hole and break them off flush. Then screw the old screws back in. Good luck ever getting them back out again, unless you use some kind of release agent on the threads, and even that might not always work.
Posted: April 2nd, 2006, 6:16 pm
by mojokoko
Cool thanks for the ideas.
Posted: April 2nd, 2006, 9:12 pm
by tin can
I would start with the larger screw idea as suggested by Charles. If that doesn't work. fill the holes with fiberglass, re pilot the holes, and put the screws back in.
Posted: April 3rd, 2006, 9:36 am
by wevans
When my nephews did that, we put larger screws but coated them in 5200 before installing
Posted: April 3rd, 2006, 10:38 am
by Hit-n-Miss
wevans wrote:When my nephews did that, we put larger screws but coated them in 5200 before installing
Put 5200 under the console lip too.