A unique website dedicated to fishing information from Florida's Northern Big Bend. This includes the area from the Econfina River west to the Apalachicola River
Make sure you know what you want....meaning if your running good with a 3 blade 17 pitch stainless prop, you will probably want to drop down 2 degrees in pitch inorder to keep the RPMs up. This is a general rule, boats, engines and various other things will effect performance.
Boy, I sure hate to continue to show my ignorance, but why stop now! What is the performance difference between a 3 and 4 blade prop? Just guessing, wondering if the 4 blade displaces more water which might impact speed? Any difference in handling between the two?
Ron Wilson wrote:Boy, I sure hate to continue to show my ignorance, but why stop now! What is the performance difference between a 3 and 4 blade prop? Just guessing, wondering if the 4 blade displaces more water which might impact speed? Any difference in handling between the two?
It may impact speed...but will excel in load carrying...I was running a 3 blade stainless and could do 40 mph by myself with a light load, a tail wind and me laying in the floor ....I got a 4 blade 15 pitch prop and I can do 38 mph with a full tournament load and another angler...best I could do with the three blade and a tournament load was 36 mph.
Four blade with grip better....only disadvantage I have seen is steering torque, but I have a fix for that, I just haven't done it yet.
Chalk, what are you running the 15 pitch on? I have a 90 merc and a four blade 17 pitch was an improvement over the 19 3 blade. I was thinking the 15 may be even better. Comments.
Seachaser wrote:Chalk, what are you running the 15 pitch on? I have a 90 merc and a four blade 17 pitch was an improvement over the 19 3 blade. I was thinking the 15 may be even better. Comments.
90 hp Yamaha
Depends how your RPMs are now, if your reaching the proper RPMs then your doing the best you can....if you go to low you will over rev the engine
the 4x I have is a 15 pitch powertech that has a large amount of cup put into it. the prop starts at 15 and transitions out to about 18. my boat does about 32.2. with a 60.No matter how I have it loaded. I have talked to people with the exact same boat,motor, and prop that have gotten up to 37mph and some that could not break more than 28. very minor adjustments can have a tremendous effect on the performance.
Barhopr wrote:my boat does about 32.2. with a 60.No matter how I have it loaded. I have talked to people with the exact same boat,motor, and prop that have gotten up to 37mph and some that could not break more than 28.
I have been meaning to talk to you about proper boat operation
If I put an RPM gauge on my motor, but am already "improperly propped"... ...how do I know if I am gauging the right RPM's to know what 4 blade prop to get?
This can get confusing to say the least.
Work 2 fish 4 days
1988 vintage 1436 Fisher Jon
1992 vintage 15 hp Merc
Redbelly wrote:If I put an RPM gauge on my motor, but am already "improperly propped"... ...how do I know if I am gauging the right RPM's to know what 4 blade prop to get?
This can get confusing to say the least.
I would say you still need the RPM gauge to figure how you're improperly propped so that you may get propped properly.
"Why does Sea World have a seafood restaurant?? I'm halfway through my fish burger and I realize, Oh man....I could be eating a slow learner."