WHICH IS BETTER

[gonefishing]

bobs machine shop jack plate or cmc,I have an actioncraft 1802 150 merc....what would be the best
trolling motor,riptide,greatwhite 24volt 75-85 lbs thrust bow mount

[Reel Cowboy]

Bobs Machine
great white 24V

[gonefishing]

10 in set back or ...and what size tm by motorguide,remote control;is it important,what about lenco trim tabs

[Mook!]

I posted a very detailed personal account of remote on minn kota co-pilot a while back, but in a nutshell, they're less functional than the foot control, and in my opinion, the remote would actually be a bad thing on a motor not equipped also with autopilot feature. Only tim I've ever found it anything but annoying is for making small left/right course corrections or occasional speed adjustments when cruising creeks on autopilot. Way more control with the foot pedal. remote might help you if you're standing on a casting deck without room for the pedal or fishing the bow with a stern-mounted motor or vice versa...physical limitations is all the remote overcomes, and there is a performance cost cause each presss of a button results in an incremental change that is not nearly as precise as what you can do on the foot control, at least on the co-pilot model.

[gonefishing]

thks

[MrGreenJeans]

I don't think you would go wrong with either jackplate. The Bob's is probably a little better quality but I hear their service if you have problems is less than stellar.